MonoFer Dosage/Direction for Use

Dosage: Calculation of the cumulative iron need: Iron replacement in patients with iron deficiency: The dose of Monofer is expressed in mg of elemental iron. The iron need and the administration schedule for Monofer must be individually established for each patient. The optimal Hb target level and iron stores may vary in different patient groups and between patients. Refer to official guidelines.
Iron deficiency anaemia will not appear until essentially all iron stores have been depleted. Iron therapy should therefore replenish both Hb iron and iron stores.
After the current iron deficit has been corrected, patients may require continued therapy with Monofer to maintain target levels of Hb and acceptable limits of other iron parameters.
The cumulative iron need can be determined using either the Ganzoni formula (1) or Table 1 as follows (2). It is recommended to use the Ganzoni formula in patients who are likely to require individually adjusted dosing such as patients with anorexia nervosa, cachexia, obesity, pregnancy or anaemia due to bleeding.
1. Ganzoni formula: (See equation.)

Click on icon to see table/diagram/image

The dose-response relationship observed with Monofer suggests that the true iron demand of IV iron is underestimated by the Ganzoni fomula if a Hb target of less than 150 g/L is used.
2. Simplified Table: (See Table 1.)

Click on icon to see table/diagram/image

Method of administration: Monofer must only be mixed with sterile 0.9% sodium chloride. No other intravenous dilution solutions should be used. No other therapeutic agents should be added. The diluted solution for injection should be visually inspected prior to use. Use only clear solutions without sediment.
Monitor carefully patients for signs and symptoms of hypersensitivity reactions during and following each administration of Monofer.
Each IV iron administration is associated with a risk of a hypersensitivity reaction. Thus, to minimise risk the number of single IV iron administrations should be kept to a minimum.
Monofer offers the flexibility of administration either as an intravenous bolus injection, as an intravenous drip infusion or as a direct injection into the venous limb of the dialyser.
Monofer should not be administered concomitantly with oral iron preparations, since the absorption of oral iron might be decreased.
Intravenous bolus injection: Monofer may be administered as an intravenous bolus injection up to 500 mg up to three times a week at an administration rate of up to 250 mg iron/minute. It may be administered undiluted or diluted in maximum 20 mL sterile 0.9% sodium chloride.
Intravenous drip infusion: The cumulative iron dose required may be administered in a single Monofer infusion up to 20 mg iron/kg body weight or as weekly infusions until the cumulative iron dose has been administered.
If the cumulative iron dose exceeds 20 mg iron/kg body weight, the dose must be split in two administrations with an interval of at least one week. It is recommended whenever possible to give 20 mg iron/kg body weight in the first administration. Dependent on clinical judgement the second administration could await follow-up laboratory tests.
Doses up to 1000 mg must be administered over 20 minutes. Doses exceeding 1000 mg must be administered over 30 minutes or more. Single doses above 1500 mg are not recommended.
Monofer should be added to maximum 500 mL sterile 0.9% sodium chloride.
Injection into dialyser: Monofer may be administered during a haemodialysis session directly into the venous limb of the dialyser under the same procedures as outlined for intravenous bolus injection.