Invanz

Invanz Dosage/Direction for Use

ertapenem

Manufacturer:

Merck Sharp & Dohme

Distributor:

Zuellig Pharma
Full Prescribing Info
Dosage/Direction for Use
The usual dose of INVANZ in patients 13 years of age and older is 1 gram (g) given once a day. The usual dose of INVANZ in patients 3 months to 12 years of age is 15 mg/kg twice daily (not to exceed 1 g/day).
INVANZ may be administered by intravenous (IV) infusion or intramuscular (IM) injection. When administered intravenously, INVANZ should be infused over a period of 30 minutes.
Intramuscular administration of INVANZ may be used as an alternative to intravenous administration in the treatment of those infections for which intramuscular therapy is appropriate.
The usual duration of therapy with INVANZ is 3 to 14 days but varies by the type of infection and causative pathogen(s). (See INDICATIONS.) When clinically indicated, a switch to an appropriate oral antimicrobial may be implemented if clinical improvement has been observed.
In controlled clinical studies, patients were treated from 3 to 14 days. Total treatment duration was determined by the treating physician based on site and severity of the infection, and on the patient's clinical response. In some studies, treatment was converted to oral therapy at the discretion of the treating physician after clinical improvement had been demonstrated.
Prophylaxis of surgical site infection following elective colorectal surgery: To prevent surgical site infections following elective colorectal surgery in adults, the recommended dosage is 1 g IV administered as a single intravenous dose given 1 hour prior to the surgical incision.
Patients with renal insufficiency: INVANZ may be used for the treatment of infections in adult patients with renal insufficiency. In patients whose creatinine clearance is >30 mL/min/1.73 m2, no dosage adjustment is necessary. Adult patients with advanced renal insufficiency (creatinine clearance ≤30 mL/min/1.73 m2), including those on hemodialysis, should receive 500 mg daily. There are no data in pediatric patients with renal insufficiency.
Patients on Hemodialysis: In a clinical study, following a single 1 g IV dose of ertapenem given immediately prior to a hemodialysis session, approximately 30% of the dose was recovered in the dialysate. When adult patients on hemodialysis are given the recommended daily dose of 500 mg of INVANZ within 6 hours prior to hemodialysis, a supplementary dose of 150 mg is recommended following the hemodialysis session. If INVANZ is given at least 6 hours prior to hemodialysis, no supplementary dose is needed. There are no data in patients undergoing peritoneal dialysis or hemofiltration. There are no data in pediatric patients on hemodialysis.
When only the serum creatinine is available, the following formula** may be used to estimate creatinine clearance. The serum creatinine should represent a steady state of renal function.
**Cockcroft and Gault equation: Cockcroft DW, Gault MH. Prediction of creatinine clearance from serum creatinine. Nephron. 1976

Click on icon to see table/diagram/image

No dosage adjustment is recommended in patients with impaired hepatic function.
The recommended dose of INVANZ can be administered without regard to age (13 years and older) or gender.
Instructions for Use: Patients 13 years of age and older: Preparation for intravenous administration: DO NOT MIX OR CO-INFUSE INVANZ WITH OTHER MEDICATIONS.
DO NOT USE DILUENTS CONTAINING DEXTROSE (α-D-GLUCOSE).
INVANZ MUST BE RECONSTITUTED AND THEN DILUTED PRIOR TO ADMINISTRATION.
1. Reconstitute the contents of a 1 g vial of INVANZ with 10 mL of one of the following: Water for Injection, 0.9% Sodium Chloride Injection or Bacteriostatic Water for Injection.
2. Shake well to dissolve and immediately transfer contents of the reconstituted vial to 50 mL of 0.9% Sodium Chloride Injection.
3. Complete the infusion within 6 hrs of reconstitution.
Preparation for instramuscular administration: INVANZ MUST BE RECONSTITUTED PRIOR TO ADMINISTRATION.
1. Reconstitute the contents of a 1 g vial of INVANZ with 3.2 mL of 1.0% or 2.0% lidocaine HCl injection*** (without epinephrine). Shake vial thoroughly to form solution.
2. Immediately withdraw the contents of the vial and administer by deep intramuscular injection into a large muscle mass (such as the gluteal muscles or lateral part of the thigh).
3. The reconstituted IM solution should be used within 1 hour after preparation.
Note: The reconstituted solution should not be administered intravenously.
***Refer to the prescribing information for lidocaine HCl.
Pediatric patients 3 months to 12 years of age: Preparation for intravenous administration: DO NOT MIX OR CO-INFUSE INVANZ WITH OTHER MEDICATIONS.
DO NOT USE DILUENTS CONTAINING DEXTROSE (α-D-GLUCOSE).
INVANZ MUST BE RECONSTITUTED AND THEN DILUTED PRIOR TO ADMINISTRATION.
1. Reconstitute the contents of a 1 g vial of INVANZ with 10 mL of one of the following: Water for Injection, 0.9% Sodium Chloride Injection or Bacteriostatic Water for Injection.
2. Shake well to dissolve and immediately withdraw a volume equal to 15 mg/kg of body weight (not to exceed 1 g/day) and dilute in 0.9% Sodium Chloride Injection to a final concentration of 20 mg/mL or less.
3. Complete the infusion within 6 hrs of reconstitution.
Preparation for intramuscular administration: INVANZ MUST BE RECONSTITUTED PRIOR TO ADMINISTRATION.
1. Reconstitute the contents of a 1 g vial of INVANZ with 3.2 mL of 1.0% or 2.0% lidocaine HCl injection*** (without epinephrine). Shake vial thoroughly to form solution.
2. Immediately withdraw a volume equal to 15 mg/kg of body weight (not to exceed 1 g/day) and administer by deep intramuscular injection into a large muscle mass (such as the gluteal muscles or lateral part of the thigh).
3. The reconstituted IM solution should be used within 1 hour after preparation.
Note: The reconstituted solution should not be administered intravenously.
***Refer to the prescribing information for lidocaine HCl.
Parenteral drug products should be inspected visually for particulate matter and discoloration prior to use, whenever solution and container permit. Solutions of INVANZ range from colorless to pale yellow. Variations of color within this range do not affect the potency of the product.
Register or sign in to continue
Asia's one-stop resource for medical news, clinical reference and education
Already a member? Sign in
Register or sign in to continue
Asia's one-stop resource for medical news, clinical reference and education
Already a member? Sign in